CVSS 3.1
Вероятност да бъде експлоатирана в следващите 30 дни (EPSS)
Атакува се
Време до експлоатация
Атакува се локално, без особени условия, с обикновен потребителски вход и без действие от потребителя.
- Експлоатация: няма данни за експлоатация
- Атаката не може да се автоматизира
Описание
Оригинално описание
The NXP LPUART serial driver (drivers/serial/uart_mcux_lpuart.c), when CONFIG_UART_USE_RUNTIME_CONFIGURE is enabled, called LPUART_Deinit() at the start of mcux_lpuart_configure(), which disables the LPUART peripheral clocks. The requested configuration is validated only afterwards (in mcux_lpuart_configure_basic), and unsupported parity/data-bit/stop-bit/flow-control values return -ENOTSUP before the clock is re-enabled. As a result, a uart_configure() request with an unsupported configuration left the LPUART in a clock-disabled state; any subsequent access to LPUART registers (poll_out/poll_in, interrupt handling, or a later reconfigure) faults on the gated peripheral and escalates to a hard fault, crashing the system. uart_configure() is a Zephyr syscall whose verifier (z_vrfy_uart_configure) only checks that cfg is readable user memory and forwards the caller-supplied configuration unchanged, so an unprivileged userspace thread with access to an LPUART device can deterministically trigger the fault, a persistent system-wide denial of service. Introduced in v2.5.0 and present in all subsequent releases until this fix, which removes the LPUART_Deinit() call and instead only disables the transmitter/receiver, leaving the clock running.
Засегнати продукти
- zephyrproject zephyr: 3.7.0 преди 4.3.1; 4.4.0 преди 4.4.2
Вид слабост
История
- 21 юли 2026 Публикувано